1. The thermostats on the temperature regulator are mostly induced temperature control. The principle is that the ambient temperature varies depending on your set temperature.When the ambient temperature reaches the set temperature, the temperature controller will automatically turn off the heating device.When the ambient temperature is lower than the set temperature, the temperature controller will automatically turn on the heating device switch.2. The integrated overheating protection device is installed in the overheating protection device to ensure high safety.When the temperature is overheated, the circuit will be cut off. When the temperature drops to the safe temperature, the heater will automatically start working.3. The thermal startup device is integrated in the heat startup device. When the heating is started, the electric heating pipe will preheat first, and the fan will be activated later to ensure that the thermal wind blows out, which is normal.When the heating is stopped, if the gear switch is placed in the fan gear, the fan will continue to work until the heat in the air duct is exhausted. If the machine is directly disconnected when the machine is overheated, the machine will blow the natural wind without cutting off the power supply.In minutes, this is a normal phenomenon in automatic cooling.4. Storage
Before preparation, the machine should be allowed to rotate for a while to clean the inside of the machine to better clean the dust on the internal element.Put the machine in a dry place to store it to avoid damage to the power cord and other components at the next use.