When installing a combined air -conditioning unit, you need to pay attention to the following safety details:
Preparation before installation:
Read and understand the installation manual and safety guide of the equipment carefully.
Check whether all tools and equipment are in a good state, and prepare the required protection equipment, such as hard hats, seat belts, gloves, etc.
Make sure that the work area is neat and clear all obstacles that may hinder work or cause slipping.
Equipment handling and hanging:
Use appropriate lifting equipment, such as forklifts, cranes, etc. to carry and hang air -conditioning units.
During the hanging process, make sure that the rope or strap is firmly fixed on the unit to avoid the unit slipping or turning.
It is forbidden to stand under the device or perform other jobs to prevent the device from falling into damage.
Installation location:
Choose a smooth, dry and ventilated position to install the air -conditioning unit.
Make sure that the installation location will not be affected by adverse factors such as direct sunlight, high temperature, humidity, and chemical corrosion.
For outdoor devices, especially at the door hosts, it should be avoided to be installed on the wall that is easily attacked or wet to reduce the risk of device damage.
Power access and lightning protection measures:
Make sure the power supply access is stable and reliable, avoiding unstable voltage or too low, causing the equipment to work properly.
Install appropriate lightning protection equipment, such as lightning protection needles, lightning protection bands, etc. to reduce the damage to the equipment for lightning.
Waterproof moisture -proof measures:
For equipment in outdoor or humid environments, waterproof and moisture -proof measures should be taken, such as waterproof hoods and waterproof materials.
Ensure that the drainage system of the equipment is unimpeded to prevent the condensate from accumulating in the device and cause damage.
Electromagnetic shielding and anti -interference:
When wiring, try to use the shielding line to reduce the effect of electromagnetic interference on the signal.
Avoid paving power cords, signal cables, etc. near pipes such as metal water pipes, trachea, or cross wiring to reduce electromagnetic interference.
Device interface connection:
When connecting the device, make sure that all interfaces are connected correctly, firmly and avoid loosening or poor contact.
Follow the instructions of the equipment to correctly connect the power, signal line, etc.
Safety operation:
During the installation process, always follow safety operating procedures and precautions.
Use suitable tools and equipment to ensure the safety and reliability of the installation process.
It is forbidden to wear protective equipment such as a helmet at the construction site.
Check after installation:
After the installation is completed, a comprehensive inspection of the air -conditioning unit to ensure its normal operation and safety performance.
Check whether the power supply, line, drainage system, etc. are running normally and meet the safety requirements.
In short, when installing a combined air -conditioning unit, it is necessary to strictly follow the safety operating procedures and precautions to ensure the safety and reliability of the installation process.
The above is the introduction of the details of the installation of the combined air -conditioning unit