Installing hot water type needs to meet the following conditions:
1. Installation location: You should choose a place where good ventilation, dry air, and near the heat source for installation.At the same time, considering the size and heat dissipation requirements of the equipment, the indoor space is needed reasonably to avoid being installed in the corner or closely attached to other items to ensure the heat dissipation effect.It is generally recommended to be installed in the middle of the room to maintain sufficient space.
2. Installation height: The installation height should be selected according to the actual situation. It is necessary to ensure the heat dissipation effect and avoid too low affect the indoor space use.Generally speaking, it is more appropriate to be about 1.5-2 meters from the ground.
3. Equipment inspection: Before installation, check the integrity of the hot water heater to ensure that the equipment is not damaged or missing.At the same time, check whether the circulating thermal pump is equipped on the water pipe road, and ensure that the motor wiring is correct.
4. Fixed body: After installing the body to the predetermined location, the body should be firmly fixed on the wall or the ground with the expansion screw or other appropriate fixing methods to ensure that the equipment will not shake or fall off during the operation.
5. Connect the wires and water pipes: Connect the wires and water pipes according to the instructions to ensure that the wiring is firm and avoid poor contact or short circuit.When connecting the line, follow the safety norms to avoid lines or moisture.
In addition, for explosion -proof hot water heater, it is necessary to prepare the required tools before installation, such as electric drills, screwdrivers, wounds, wiring pliers, etc., and operate according to the installation steps.During the installation process, we need to pay attention to safety to ensure that the equipment can work normally.
Finally, the hot water heater needs to be kept clean during installation and use, and regularly clean the water pipe cavity of the water pipe of the heat exchanger to avoid the accumulation of scale accumulation affecting the heat transfer effect.At the same time, it is necessary to regularly check the tightness of each connection. If there is looseness, it should be tight immediately.
The above is the condition for installing the hot water heaters