In the fire -discharge smoke installation work, I summarized some problems that everyone often encountered. The following are listed in four to learn about it with you.
1. Install the staff in all aspects of the specifications and methods, methods, methods, and the rotation orientation of the rotation of the centrifugal leaf wheel and the input orientation of the cyclone.Before installation and use, you need to check whether the centrifugal impeller has occurred in each other. It is necessary to conduct a comprehensive inspection of each component, and focus on whether the fan blades are destroyed or deformation due to transportation.If the above situation occurs, it can be installed on the fire smoke exhaust fan until it is repaired.
2. The air duct connecting the import and export trade of fire exhaust fan should have a supporting point of the independent support. The net weight of the pipeline is not allowed to be added to the component of the centrifugal fan. When the centrifugal fan is installed, the level of the centrifugal fan must be paid to the centrifugal fan.The connection between the fusion surface of the fan and the road base shall be adjusted and cannot be forced to connect.
3. After installation of fire foam fan, whether it is too tight or rubbing according to the rotating centrifugal impeller, you can connect to the switch power supply for testing without abnormalities.
4. At the cable level, the fire firing fan wiring must be correct. The centrifugal fan shell should be properly grounded, and the ground must be reasonable.The switching power supply to provide centrifugal fan must be detailed, and it must meet the relevant regulations.
The above is a common problem encountered in the installation of fire fire exhaust fan. I hope it will be helpful to you.If you want to know more about related information, please pay more attention to us--