The asphalt storage tank is used as a thermal source, coal -fired, gas or fuel furnace as thermal source, compulsive circulation from the thermal pump, and heat the asphalt to the use temperature.The outstanding characteristics of this asphalt tank are rapidly heating, that is, it can produce high -temperature asphalt in large quantities, and can save heat energy and temporarily extract a small amount of thermal asphalt.The hot asphalt of 160 ° C generally does not exceed 4 hours.Thermal oil -type asphalt storage tank, low pressure and high temperature, safety and hygiene.Using the "partially removed asphalt device", high -temperature asphalt can be quickly removed from large asphalt oil tanks without the need to heat the asphalt storage tank as a whole.
The asphalt tank is "Local Quick Internal Heating asphalt Storage Type Heater Device". This series of currently advanced fast, energy -saving and environmentally friendly thermal asphalt equipment, direct heating and mobile equipment of the product, products not only heating speed and fuel saving, no pollution, no pollution, no pollution, no pollution, no pollution.The operation is simple and easy, the automatic circulation program enables the asphalt to enter automatically as required. The campaign, heater, filter, asphalt, asphalt pump temperature monitor, water level monitor, steam generator, preheating system, pipeline and asphalt pump pressure leakage system, The steam combustion system, the tank body and other components system, unload the oil into the pot, all are not installed in the tank (inside) to form a compact body structure.
Pay attention to the design of the asphalt insulation tank:
1. Pay attention to the production design. Try to avoid too much asphalt at the bottom. It is difficult to eliminate this problem. As much as possible, the asphalt is less than one centimeter of use, which can also reduce the degree of waste.
2. The design of the asphalt tank should meet the specific requirements and ensure that some demolition of the asphalt device can be combined with the heating technology of the branch, so as to produce a large number of finished products and meet the requirements of small batches of production.Similarly, asphalt heating irrigation is also the design requirements.
3. If the device can solve the problem of taking out the asphalt, the device can directly produce high -temperature products, which is very convenient.They need to ensure that the continuous working time of the equipment cannot exceed an hour, so they need to set the method of heat oil cycle, low -pressure and high temperature production without danger.
Washing asphalt insulation tank:
Diesel is generally used in the asphalt tank. If you have a certain thickness, you can clean it through the physical method first, and then wash it with diesel.Start the ventilation system when the cave library is used to suck to ensure the ventilation of the operating venue.Oil and gas poisoning accidents are prone to occur during removal of tank bottom dirt, and protective work must be done to prevent poisoning.In addition, it is necessary to check the technical status of the ventilation equipment to start the ventilation of ventilation.