When installing electric heating curtain machines, you need to pay attention to the following aspects:
Power and wire:
· You need to calculate the switching power supply and the sectional area of ??the wires in advance to ensure that the switching power supply wire of the installation location meets the standard of the air curtain.
· Based on the electricity of the electric heating curtain machine, it is reasonably wiring.The power plug current of the air curtain machine is more than 10A, and the heating -type air curtain machine is above 30A. Therefore, try not to use the same power socket as possible as other electrical equipment to ensure that the power socket is used.
· When installing a three -phase (380 volt) electric air curtain machine, the zero line of the air curtain machine should not be connected to the protection ground line of the three -phase power supply there to avoid directly damaging the air curtain.
Installation position and spacing:
· It is recommended to choose to install at the open space at the door or at the air outlet and 2.5m from the ground to ensure that it can achieve a better thermal insulation isolation effect.At the same time, the electric heating clearance machine is suitable for installation in large spaces with large ventilation volume to avoid installation in small spaces such as aisles or narrow doors, so as not to reduce the insulation performance.
· When the width of the installation door is larger than the width of a single wind curtain machine, two or multi -typhoon curtain machines need to be used together. At this time, the distance between the two air curtain machines should be between 10mm and 30mm.
Installation Environment:
· The curtain machine cannot be installed in areas that are easy to splash water, or are exposed to high -temperature, irritating gases for a long time.
installation steps:
· Installation bracket is the basis of the entire installation, and it needs to ensure firmness and stability.
· When connecting the power supply, the connection method of the power supply and other wiring beams needs to be determined according to the appearance of the device. Pay attention to whether there is a conflict with other electrical equipment. The correct wiring should be performed according to the equipment instructions when the wiring.
· Wind wheel is a working component, which needs to be installed gently on the bracket of the curtain machine. At the same time, pay attention to the gap between the wind wheel and the case, and the locking of the screw.
Debugging and checking:
· After the installation is completed, you need to debug the machine. After turning on, check whether the machine runs normally, adjust the wind speed and temperature to achieve better results.
· Before installation, power the test machine to power the test machine. After confirming that the air curtain machine work is normal, install it in place.
· If there is an abnormal noise when the air curtain is powered on, it may be that the impeller and the case are friction. At this time, the supplier should be contacted and do not continue to install it.
Precautions:
· The output power of the electric heaters is large, the multiple temperature corresponds to different power, and different power is applicable to different room temperature.
· The heating -type wind curtain machine cannot directly disconnect the power of the curtain machine when it is turned off. It should be turned off first. After the temperature of the equipment cools down, the power of the curtain machine is disconnected.
Please ensure that the above steps and precautions are followed to ensure the correct installation and normal operation of the electric heating curtain machine.If you have any questions about the installation process, it is recommended to contact the professional installer or manufacturer to guide.