Electric thermal curtain machines may encounter a variety of faults during use. The following are some common faults and brief descriptions:
1. No hot air or temperature is lower than the set temperature:
Reason: It may be that the outlet is too ash, causing blockage, or too much ash accumulation of the heater and cause damage.
Solution: First check and clean up the dust on the outlet and heater, and then check whether the power supply is missing and whether the external environmental temperature is too low.
2. The machine is not running, no wind:
Reason: It may be the shortage of power supply, switch damage, impeller loosening, motor or capacitor damage.
Solution: First check the power supply and switch, then check whether the impeller is loose, and finally check whether the motor and capacitors are damaged.
3. Noise becomes larger:
Reason: It may be caused by unstable installation or loosening internal accessories.
Solution: First exclude the installation factors, and then check whether the facial network, the air guide board, and the fan impeller are loosened and shifted.
4. After power -on, the wind curtain machine does not move:
Reason: It may be a power circuit failure, control circuit failure or power switch failure.
Solution: Check whether the power wiring is connected correctly, confirm whether the line is damaged or short -circuit, and detect the insurance inside the machine.
5. Failure to the windows remote control:
Reason: It may be insufficient battery battery, signal interference or remote control damage.
Solution: Replace the remote control battery to check whether there is a sources of signal interference. If the problem is still, the remote control may be replaced.
6. Run water leakage of hot water curtain machine:
Reason: It may be that the water pipe connection is loose, the water tank is ruptured or the sealing pieces are aging.
Solution: Check whether the water pipe connection is tight, replace the broken water tank or an aging sealing part.
7. Electric thermal curtain machine is naturally windy while there is a hot air:
Reason: It may be that the heater part is damaged or the fan rotates uneven.
Solution: Check whether the heating device is damaged, and check the turning of the fan at the same time. If necessary, replace or repair.
8. In the work, the relay is noisy, and the harsh noise is emitted:
Reason: It may be poor in internal contact or damage to the relay.
Solution: Check and clean up relay contacts. If the problem is still, the relay may be replaced.
In daily use, in order to reduce the occurrence of the above failure, it is recommended to clean and maintain the electric heating curtain machine regularly, such as cleaning the dust on the outlet and the heater, and checking the power lines and switches.At the same time, we must also pay attention to the use of the environment to avoid use in a humid and dusty environment.If you encounter a failure that cannot be resolved, it is recommended to contact the professionals in time for maintenance.
The above is a common failure of electric heat curtain