If we find that the stainless steel centrifugal blades are a little cracking, we must immediately reasonably repair it. This will not only continue to reduce the operating noise of the box, but also increase the period of stainless steel centrifugal use to ensure the actual effect of operating the operating trend of stainless steel centrifugal development.
How to deal with the cracks of the blade of stainless steel?
The key way is to supplement the welding part of the blades according to the wear -resistant welded wire. Pay attention to the wear -resistant stack of wear -resistant stacked welding of the leaves and the damaged parts of the gear board during the entire process of welding of the blade welding of the stainless steel fans.The excellent connection at the point, A can mostly pile welded to 8mm thick, and can be welded into a rubber -like pattern.
In order to better reduce the deformation level of the blade of the centrifugal fan, the symmetrical welding method must be selected during the whole process of pile welding to maintain the basics.It can also be used according to the spray paint method at the same time, the cracks are repaired by itself. Pay attention to how much the consumed is to ensure the net weight balance of all the leaves of the company.Adjust, pay attention to the research ideas for these harmful leaves, although it is not simple, it is not for a long time. The problem of more than a month must be checked and analyzed again.
The fissure repair method of stainless steel fans can also be used, but the cutting method can also be selected, but the blankets have sufficient thin thickness. If thin thickness is not allowed, these methods cannot be selected, and this is also an irreversible repair method.