The smoke and fire prevention valve not only obtained in many industrial production industries, but also obtained universal use in civilian engineering buildings.However, it is necessary to clean it after a period of use. The method is as follows: to ensure the actual effect of the application of smoke and fire prevention valves. In the process of applying smoke and fire prevention valves, we must take the waterproof and rainproof countermeasures of measures.Eliminate some stains and dust inside the smoke discharge fire prevention valve.It is very critical to do some safety protection countermeasures before cleaning the smoke discharge fire prevention valve.It is necessary to do a good job of the insulation layer to prevent the risk of electric shock accidents when cleaning smoke and fire prevention valves.Tobacco -fire -proof valve wings are not dirty, then cleaning with a high -pressure rubber tube;
If the smoke and fire fire valve wings are dirty, you must use the wing tablet cleaning agent the aqueous solution to spray and spray the wings, and then wash it with water until the smoke -proof fire valve wings will show the metal texture.After the preparation of cleaning smoke and fire prevention valves, the filter of cleaning smoke and fire prevention valves. Because the filter of smoke and fire prevention valves is very vulnerable to environmental pollution in the normal application process, we are inWhen cleaning the filter of smoke and fire prevention valves, it can clean the dirt by tap water. If there are oil traces in the smoke fire prevention valve filter, we can apply some weak alkaline cleaning agents to clean it, and then use water to carry out cleaning until washing.
The above is the introduction of how to clean the smoke and fire fire valve. I hope the above content can be helpful to everyone. Thank you for your viewing and support. In the later period