The installation steps for centrifugal hot water and air screen are as follows:
1. Preparation: Prepare the tools and materials required for installation, such as screw knives, electric diamonds, swelling tubes, insulation materials, etc., and check whether the appearance and accessories of the equipment are intact.
2. Fixed device: According to the different installation positions, you can choose the expansion bolt or stand to fix the device on the wall or roof.When fixed equipment, you need to pay attention to the level and verticality of the equipment.
3. Connect the pipeline: Connect the hot water entrance of the equipment to the exit to the hot water pipeline to ensure that the connection is well sealed and avoid the occurrence of leakage.At the same time, the power cord of the device needs to be connected in accordance with the requirements and take safety protection measures.
4. Debugging: After the installation is completed, you need to debug the device to ensure the normal operation of the equipment and achieve the expected heating effect.During the debugging process, the parameters of the device need to be adjusted and optimized to meet the actual needs.
In addition, you need to pay attention to the following issues:
1. Make sure the installation location of the centrifugal hot water and air screen is well ventilated, stay away from flammable items, and avoid being installed in a wet or easy -to -impact place.
2. During the installation process, ensure that the equipment is placed smoothly to avoid bumps during transportation and cause the impeller to deform or sweep the hall.
3. During the use process, start the fan first, and then adjust the temperature and air volume as needed to increase the service life of the fan and electric heating components.If you find abnormal sounds, odor or smoke, etc., you should immediately stop and check.
4. Under normal working conditions, the bearings of centrifugal hot water and air screens need to be cleaned and refueling regularly.When cleaning, wash the dirt in the bearing and then inject the appropriate amount of fat.The volume of refueling cannot exceed 2/3 of the bearing space.
The above is the installation of centrifugal hot water and air screen