Today, I want to introduce the cleaning methods of each component of the centrifugal box in detail, which can clean the centrifugal we use.It is hoped that many users can maintain our centrifugation during use.In order to completely clean the centrifugation, the entire centrifugal shell must be removed first, and then decomposed.The internal structure of the centrifugal shell is very small, and it needs to be very careful when disassembling.Keeping each fixed bolt to prevent pollution during disassembly is a very important point for disassembling the centrifugal shell.
First, remove the centrifugal fans and the bearing shell.This is the outer part of the entire centrifugal fan shell.If you do not disassemble first, other components cannot be disassembled.The part that cannot be disassembled and cleaned by the centrifugal fan shell is the motor, mainly because the motor may be burned.Although all parts should be used after disassembling all parts, the tools should be used to wipe the oil and dust components accumulated, and then assembled, there are many places to pay attention to during the assembly process.
In addition, after the centrifugal air supply machine shell is installed, be careful not to have any leakage tools.The normal work of a centrifugal fan shell must be avoided.The weight of the gas supply pipes shall not be applied to the centrifugal fan shell during the installation process.
In addition, it is important to note that when the user has special needs to install a centrifugal fan shell at a specified angle, the rear disc of the centrifugal fan shell must be appropriately rotated.After the installation step is completed, the rotor of the centrifugal fan shell must be manually moved to check whether it is too tight or collided.After these tasks are completed, centrifugal fan shells can be used for trial operation.
During the trial operation, it mainly observes whether the bearing temperature of the centrifugal curtain machine is normal.Generally speaking, the temperature of the bearings must not exceed 40 degrees of the ambient temperature, and the average root vibration rate of the bearing department shall not exceed 6.3 mm/second.When the centrifugal curtain case is obviously vibrated or the temperature of the bearing suddenly rises during the trial operation, the trial operation of the centrifugal fan shell should be stopped immediately.
The above introduces the cleaning method of various components of the centrifugal curtain machine. When equipped with cleaning the centrifugal curtain machine, first use the same size to flatten the iron flat, and then tighten the bolts.It can enter the normal operation after passing the trial operation.