Farm often chooses to warm and warm in winter.In order to ensure the heating effect of breeding heating, before installing the heating, all aspects of the inspection should be accepted to ensure that the equipment is in a good state before installation and use.The inspection and acceptance of inspection before breeding warm installation mainly includes the following aspects: 1. Whether the packaging of the inspection is intact, whether the accessories required for the inspection requirements are complete, and check whether the parameters on the breeding thermal sign meets our requirements.Model.2. The inspection was damaged.If a serious collision occurs during transportation, the equipment will be damaged.Therefore, all aspects of the appearance of the device should be checked to see if there are any deformation, abrasions or other damage.Copy the heating parts of the breeding for inspection and inspection, check whether the firmware is loose or falling off, and whether the part is damaged.If you have any questions, repair or replace before installation.3. The insulation resistance between the shell and the motor winding should be detected to ensure the safety of electricity consumption.The insulation resistance between the shell and the motor winding should be greater than 0 or 5 trillion euros. Otherwise, the motor winding should be dry, and the temperature should not exceed 120 during drying.The breeding heating acceptance inspection mainly includes the above content. Before installation, you must conduct a comprehensive inspection to ensure the quality of the machine.
The above is the acceptance of the breeding heater. I hope that the above content can be helpful to everyone. Thank you for your watching and support. In the later period, more information will be sorted out. Please pay more attention to us.